Finalising your subscription

To validate your subscription, please enter the 6-digit code that we have just sent you by e-mail.
X Finalising your subscription

Use of cookies

This website uses cookies to optimize your user experience. By navigating on this website, you consent to this use. To find out more about cookies, consult our privacy policy.
running gear

running gear

Most JOSKIN single axle vehicles have a bolted axle. The running gear can thus be easily moved when a change in load (eyelet weight/axle weight ratio) is required, especially when a rear implement is added to the original machine (e.g. slurry tanker with injector, tipping trailer with grain auger, etc.). The bolted axle also makes it easier to change tyres.

The double-axle running gear with "Roll-Over" bogie offers, thanks to its design, a complementary suspension system to the wheels as well as a larger contact surface with the ground. It consists of 2 axles connected by parabolic leaves and is bolted to the chassis by what is commonly known as "the table", a large support that balances and distributes the loads in an optimal way. With its maximum clearance of 240 mm, it can absorb the irregularities in the terrain. Thanks to the position of the cross-axis under the spring leaves and the position of the axles above the ends of these same leaves, a pull line pushes the front axle over the obstacle. The advantages of this design are manifold: in addition to a lower centre of gravity and thus a better stability, the required traction power is significantly reduced. JOSKIN assembles its own bogies, which means that they can be made to measure for your vehicle. The distance between the axles and therefore the length of the leaves can be adapted to each machine, e.g. according to the choice of tyres. All JOSKIN “Roll-Over” bogies are bolted and therefore movable.